Telkom Fax100e, Инструкция по эксплуатации

Страница: 36 / 60

14
T
O RECORD OUTGOING MESSAGE
1
1. Press the key
until the display shows:
TAD SET-UP
2. To confirm the setting, press the key:
The display shows:
ICM ON SPEAKER
3. Press the key
until the display shows:
RECORD OGM1 !
4. Press the key:
The display shows:
LIFT HANDSET
5. Lift the handset.
The display shows:
TO RECORD
6. To start recording the message, press the key:
The display shows:
RECORDING 1 9
You have 20 seconds (counted on the display from 19 to
00) to record your message:
• if the message lasts less than 20 seconds , when you
reach the end of the message hang up or press the
key or the key. If you press the key, the fax
machine will not automatically play back the message that
you have recorded.
• if the time available runs out , the fax machine emits a
brief beep and automatically plays back the message you
have recorded.
Then hang up.
In both cases, to return the fax machine to the initial stand-
by mode, press the key.
notE
If the volume of the message is too low or too high you can
regulate it, during playback, using the key. The display shows
the volume level set in the top right-hand corner.
T
O LISTEN TO OUTGOING MESSAGE
1
1. Press the key
until the display shows:
TAD SET-UP
2. To confirm the setting, press the key:
The display shows:
ICM ON SPEAKER
3. Press the key
until the display shows:
PLAY OGM # 1
4. To listen to message 1 recorded previously, press the key:
The display shows:
PLAYING
When it gets to the end of the message, the fax machine
automatically prepares to record a new OUTGOING MES-
SAGE 1. In this case, if you like, you can change or replace
the message recorded previously by repeating the record-
ing procedure.
5. To return the fax machine to the initial stand-by mode, press
the key:
T
O RECORD OUTGOING MESSAGE
2
Record outgoing message 2 as you recorded outgoing message 1,
modifying the
step 3 as follows:
Press the key until the display shows:
RECORD OGM # 2
notE
Bear in mind however that you only have 10 seconds.
T
O LISTEN TO OUTGOING MESSAGE
2
Play back outgoing message 2 as you played back OUTGOING
MESSAGE 1 modifying the
step 3 as follows:
Press the key until the display shows:
PLAY OGM # 2