NL865H2 Hardware Design Guide
1VV0301616 Rev. 7
Page
29
of
67
2020-04-20
Power On
The NL865H2-W1 module is automatically powering on itself when supplied.
NOTE:
To check if the device has powered on, the hardware line VAUX/PWRMON
should be monitored.
The power-off duration is required to be at least 5s before the module is
powered on.
Unconditional Restart
To unconditionally restart the NL865H2-W1, the pad RESET* must be tied low for at least
400 milliseconds and then released.
The hardware unconditional Restart must not be used during normal operation of the
device since it does not detach the device from the network. It shall be kept as an
emergency exit procedure to be done in the rare case that the device gets stuck waiting
for some network or SIM responses.
The unconditional hardware restart must always be implemented on the boards and the
software must use it as an emergency exit procedure.
5.3.1.
PIN DESCRIPTION
Signal
Function
I/O
Pad
RESET*
Unconditional Reset of the Module
I
55
There are two way to reset the module you can choose:
1
：
Through AT command of “AT+TRST”
2
：
Reset the module through RST pin
When the software stops response, you can pulled down RST 400ms to reset the
module's system.
Содержание NL865H2 Series
Страница 1: ...01 2017 Mod 0818 2017 01 Rev 0 NL865H2 Hardware Design Guide 1VV0301616 Rev 7 2020 04 20...
Страница 19: ...NL865H2 Hardware Design Guide 1VV0301616 Rev 7 Page 19 of 67 2020 04 20 LGA Pads Layout TOP VIEW...
Страница 57: ...NL865H2 Hardware Design Guide 1VV0301616 Rev 7 Page 57 of 67 2020 04 20...
Страница 67: ...01 2017 Mod 0818 2017 01 Rev 0...
