Telit Wireless Solutions LE910-SKG, Справочник команд AT

Страница: 242 / 273

LE910-SKG AT commands reference guide
80437ST10619A Rev.1 – 2014-09-16
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 242 of 273
#STIA - SIM Tookit Interface Activation
AT#STIA=?
Test command returns the range of available values for the parameters <mode> and
<timeout> .
Note Just one instance at a time, the one which first issued AT#STIA= n (with n different
from zero), is allowed to issue SAT commands, and this is valid till the same
instance issues
AT#STIA=0 .
After power cycle another instance can enable SAT.
Note A typical SAT session on AT interface starts after an #STN: 37 unsolicited code is
received, if enabled(see above). At that point usually an AT#STGI=37 command is
issued (see #STGI) and after the SAT main menu has been displayed on TE an
AT#STSR=37,0,x command is issued to select an item in the menu (see #STSR)
#STGI - SIM Tookit Get Information
AT#STGI=
[<cmdType>]
#STGI set command is used to request the parameters of a proactive command
from the ME.
Parameter:
<cmdType> - proactive command ID according to 3GPP TS 102.223 (decimal);
these are only those command types that use the AT interface; SAT
commands which are not using the AT interface (not MMI related SAT
commands, e.g. PROVIDE LOCAL INFORMATION) are executed
without sending any indication to the user
1 - REFRESH
5 - SET UP EVENT LIST
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE (not supported)
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM
37 - SET UP MENU
40 - SET UP IDLE MODE TEXT
Requested command parameters are sent using an
#STGI indication:
#STGI: <parameters>
where
<parameters> depends upon the ongoing proactive command as follows:
if <cmdType>=1 (REFRESH)