1VV0301455, Rev 1.1
Copyright © 2017 Telit. All rights reserved.
This Quick Start Guide will walk you through the steps required to
demonstrate HomeKit ADK on GS2200M EVB (Evaluation Board).
GS2200M Hostless HomeKit
Supports GS2200 Modules
ADK Quick Start Guide
The GS2200M_EVB3 has the GainSpan Wi-Fi module and the
Apple Wireless Accessory Configuration (WAC) installed on the
board. Your kit contains:
•
Quick Start Guide (this document)
•
GS2200M_EVB3 Evaluation Board with WAC
•
Serial Cable (USB to Mini-USB)
•
Preloaded Firmware
•
Flash Programming Tool
•
iOS devices with the Home APP from iOS store.
1
Build the Firmware
Step
3
Open GainSpan Serial Flash Programmer GUI applica-
tion from "\Tools\GS_programming_tool\gs2k_flashprogram.exe"..
Step
4
Select the interface and the port with Baud rate 921600.
Click
Check Connection
.
Step
5
Once the “Connection OK” is displayed, select “Super
Block” and “Current Firmware version” that is located in
“\QuickStart”
.
Step
6
Click
Erase and Program Button
.
A green check mark at the lower-right corner of the application win-
dow, indicates successful programming of the module with a dis-
play.
Step
1
https://wifi.telit.com/secure/login
SDK
Builde
r tab and proceed to select the following options for ADK
package as shown below:
If you do not have a login, sign up and register for a Portal account
at:
https://wifi.telit.com/secure/register
Step
2
Click
Next
to navigate to the build option.
Step
3
Click
Build
to generate the HomeKit binaries. The build con-
figuration is submitted and a confirmation e-mail is sent notifying that the
HomeKit Custom package is complete and ready to download.
Download and unzip the package, for firmware binaries.
2
Program the GS Module
Step
1
Plug the mini-USB cable, one end of the
USB
port to
GS2200MIZ board USB0 and the other end of the USB port to the com-
puter or laptop.
Step
2
Turn the PROGRAM/RUN switch to
PROGRAM
mode on
the EVB and perform a power cycle
(switch OFF and switch ON the
power switch)
