TELIKOU
SKYLINE SK-100 / SK-190 Wireless Intercom
7
2. USB Connector
External power bank supplies 5VDC
Computer Data port
3. Antenna Sequence Number
Two digits coding switch. The number at the top of the chart is the antenna number
corresponding to different dial positions
4. Register
Belt pack should register with all antennas that belt pack may roam to.
A) Pairing Belt Pack
Press and hold the register button until the indicator flash. Belt pack enters setting menu and
selects registration. Once the indicator becomes solid, it means that the pairing process is
completed. Antenna backs to normal working mode.
B) Delete Belt Pack
Make sure all the belt packs which are paired with this antenna is turned on. Press and hold
the register button until the indicator flash. Press register button 7 times will delete all the belt
pack pairing.
Note: If belt pack is not turned on before antenna deletes belt pack pairing. This belt pack
must pairing again with same antenna otherwise this belt pack can not work properly.
Or this belt pack must be reset before use.
5. Power and Registration Indicator
After power on, the indicator light is always on. When the antenna enters the registration
state, the indicator flashes slow (1s). After pairing finished, the indicator light becomes
always on.
6. Active Antenna Connector
E1 connector. Antenna connects to base station through CAT5 cable.
Pin 1 --- GND
Pin 2 --- 12VDC
Pin 3 --- Audio Input +
Pin 4 --- Audio
Pin 5 --- Audio Output -
Pin 6 --- Audio Input -
Pin 7 --- Control Signal
Pin 8 --- Control Signal
