![Telian Corporation MTD-7500 Скачать руководство пользователя страница 6](http://html1.mh-extra.com/html/telian-corporation/mtd-7500/mtd-7500_manual_1083486006.webp)
- 11 -
BLASTING AREAS
To avoid interfering with blasting operations, turn your phone OFF when in a
“blasting area” or in areas posted: “Turn off two-way radio.” Obey all signs and
instructions.
POTENTIALLY EXPLOSIVE ATMOSPHERES
Turn your phone OFF when in any area with a potentially explosive atmosphere
and obey all signs and instructions. Sparks in such areas could cause an explosion
or fire resulting in bodily injury or even death.
Areas with a potentially explosive atmosphere are often but not always clearly
marked. They include fueling areas such as gasoline stations; below deck on
boats; fuel or chemical transfer or storage facilities; vehicles using liquefied
petroleum gas (such as propane or butane); areas where the air contains
chemicals or particles, such as grain, dust, or metal powders; and any other area
where you would normally be advised to turn off your vehicle engine.
FOR VEHICLES EQUIPPED WITH AN AIR BAG
An air bag inflates with great force. DO NOT place objects, including both installed
or portable wireless equipment, in the area over the air bag or in the air bag
deployment area. If in-vehicle wireless equipment is improperly installed and the
air bag inflates, serious injury could result.
- 12 -
2. PREPARING YOUR PHONE FOR USE
2.1 Install the battery
•
Hold the battery and handset for each hand.
•
Fit the battery into the hole at the bottom of back side of the handset.
•
Softly press the top area of battery.
•
You can here the “Click” sound to complete install the battery.
Caution:
To prevent injury or burns. Do not allow metal objects to contact the
battery terminals. Do not disassemble. Use only the same type of procured
original batteries. Must be disposed of properly.
2.2 Remove the battery
Note:
Switch the phone off before removing the battery!
•
Slide out the hold button at the backside of handset.
•
Place your finger at grooved edge area, and then pull out the battery.
2.3 Charge the battery
①
Connect the lead from the charger to the bottom of the phone.
②
Connect the charger to an AC wall outlet. The battery indicator bar starts to
scroll.
Note:
If the battery is totally empty, it may take a few minutes before the
charging indication appears on the screen.
Tip:
The phone can be used while charging if the phone is switched on.
Note:
Disconnect your phone from the charger if the phone becomes hot during
a call.
③
The battery is fully charged when the battery indicator bar stops scrolling, and
the Battery full text is briefly displayed if the phone is switched on. Charging
time depends on the charger and battery used.
④
Disconnect the charger from the AC outlet and the phone.