Quick Start Guide
2
Hardware Overview
Hardware Overview
The Front LEDs
The Rear Ports
* Note 1. For advanced reset and restore setting, please refer to user manual.
.
2. For WPS configuration, please refer to the WPS section of user manual.
Connect with the
supplied power
adapter.
Connect the supplied
RJ-11 cable to this
port when connecting
to the ADSL/
telephone network.
(1)
WPS
WPS: Press 2-6 seconds until WPS LED
flashes green to trigger WPS function.
*2
(2)
Wireless ON/OFF Switch
Wireless ON/OFF Switch: Press over 6
seconds after WPS LED is off to switch on
wireless function. Press over 6 seconds
again to disable wireless function.
Flash green when
WPS configuration
is in progress.
Lit red when WAN port
fails to get IP address.
Lit green when WAN
port gets IP address
successfully.
Connect your
computer to a
LAN port with
the Ethernet
cable included.
Power
ON/OFF
switch
Blink green when power is
on and system is booting.
Lit green when the system
is ready. Lit Red if the
system is dead.
Lit green when a wireless
connection is established.
Blink when data is being
sent / received.
Lit green when the device
is successfully connected
to an ADSL DSLAM. (“Line
sync”).
When the device
power is on,
press to reset or
to restore its
factory default
setting.
*1
Antenna
Lit when USB device
is connected to the
router.
Connect the USB
cable to this port.
Lit when connected to an
Ethernet device. Lit green when
the speed of transmission hits
10/100Mbps; Blink when data is
being Transmitted / Received.
