KITS
650 / 800
Reception
TV Satellite
18
LNB IN
DC13/17V
AUDIO
L
R
230VAC~
50Hz/30W
VCR
DECODER
TV
Connect the LNB and the receiver by using a T100 cable.
A SCART connector is used between the receiver and the TV.
Connect the unit to the mains. An LED lights up on the front of the receiver. This indicates that the unit is in
“STANDBY” mode.
NOTE:
Before starting to use the receiver, we recommend that you read the user manual carefully.
Fig. 19
5m
m
5m
m
CONNECTIONS
LNB IN
DC13/17V
AUDIO
L
R
230VAC~
50Hz/30W
VCR
DECODER
TV
LNB IN
DC13/17V
Fig. 17
Fig. 18
HOW TO START TO USE THE UNIT
Read the receiver’s user manual, and follow these steps:
Select a program of the satellite that wishes to receive by pressing the
corresponding channel number on your remote control.
To do this, you can refer to the channel list at the end of the user manual.
If you have carried out all these steps correctly, you should now be receiving Astra. If not or if the picture is blu-
rred, carry out a fine adjustment of the “b” angle (fig. 16) until you obtain a better picture. Afterwards, do the
same for the “a” angle (fig. 14).
Once the installation is complete, make sure that all the screws are tightly secured to avoid unwanted move-
ments which may cause you to lose the signal.
Receiving the satellite
