Teletronics International EZPlatform Plus, Руководство пользователя

Страница: 9 / 29

allows you to send/receive data and power the EZPlatform™ with a single cable. When
connecting the antennas, care must be taken so that the antennas are properly mounted to
avoid mutual interference, especially if both wireless interfaces will be operated in the same
802.11 mode.
WLAN1 and WLAN2 are the fixed designations for the two wireless interfaces.
WLAN1 is wired to the antenna port that is closer to the hinges of the NEMA 4 enclosure;
WLAN2 is wired to the antenna port farther from the hinges of the enclosure.
Setup Requirements
CAT5/5e Networking Cable.
At least one computer installed with a web browser and a wired or wireless
network interface adapter.
All network nodes installed with TCP/IP and properly configured IP address
parameters.
2.2 Status LEDs
The behavior of the LEDs mounted on the enclosure is explained in the following table.
LED Position Status Interpretation
Power Left Solid on Power on
Off Power off
Ethernet Center On Ethernet link
Off No Ethernet connection
WLAN1 Center Solid on Associated to an AP (in SU mode)
Solid on (in AP mode)
Off Radio card not detected / wireless off
WLAN2 Center Solid on Associated to an AP (in SU mode)
Solid on (in AP mode)
3. EZManager
To help you administer your network easily and effectively, Teletronics offers free network
administration software called EZManager, which is compatible with virtually all Teletronics