Teletronics International Inc.
11M Wireless Pcmcia Card
Page 4 of 35
Chapter 2 Hardware Installation
This chapter describes the instructions that guide you through the proper hardware installation of your
11Mbps Wireless PC Card.
2-1 System Requirements
In order to use the 11Mbps Wireless PC Card, your computer must be equipped with the following:
1. A PCMCIA Type II slot, and a PCMCIA card and socket services compliant with revision 2.10
of the PCMCIA specification (or higher).
2. Windows 95/98/ME/NT/2000 (with a Windows installation CD-ROM, diskettes for use during
installation)
3. Minimum 500 Kbytes free disk space for installing driver and utility program.
2-2 Hardware Installation for 11Mbps Wireless PC Card
To install the 11Mbps Wireless PC card, please do the following:
1. Find an available Type II or Type III PCMCIA slot in your notebook computer.
2. With the PCMCIA adapter’s 68-pin connector facing the PCMCIA slot and its label facing up,
slide the PCMCIA adapter completely into the PCMCIA slot.
Fig Insert the 11Mbps PC Card into the notebook.
NOTE:
The PCMCIA slot allows “hot swap” of PCMCIA adapter. You may therefore insert
or remove your 11Mbps Wireless PC Card from the slot whenever you like even when
the power of your computer is on. However, you are advised to always disable the
PC card prior to removing the card from the PC card slot. This will allow the
Windows operating systems to log off from the network server. Disable the driver
properly and disconnect the power to the PC card slot.
