TELETRAC NAVMAN Qtanium 100, Руководство по установке

Страница: 7 / 10

Qtanium 100 | Installation Manual
7
4
Installation
1. Record the MSN (Module Serial Number) shown on the Qtanium 100 label, and the
asset number.
2. Select a mounting location.
3. Mount the Qtanium 100 using one of the following three methods:

Screws - Use the 4 mounting screws and 4 flat washers. Position each flat
washer between the screw head and the Qtanium 100 housing.

Bolts - Use the 4 bolts, 8 flat washers, and 4 nuts. Position a flat washer
between each bolt head and the Qtanium 100 housing, and another flat
washer between each nut and the asset.

Magnets - Use the optional Magnetic Mounting Kit. Each magnet MUST be in
contact with the mounting surface. At one end of the Qtanium 100, position
a flat washer over each magnet screw, between each nut and the Qtanium
100 housing. At the other end, position the lanyard tab over the 2 magnet
screws then secure using 2 flat washers and 2 nuts. Wrap the lanyard around
or through the chassis or a locking rod then attach both end loops to the
quick link. Attach the quick link to the remaining hole in the lanyard tab.
4. Remove the activation magnet (under the blue tape) from the Qtanium 100. This
automatically activates event reporting and the Qtanium 100 sends an event to
DIRECTOR.
5. Keep the activation magnet so that event reporting can be disabled if the Qtanium
100 is removed from the asset.
6. Position the asset outside, in a location that has a good view of the sky and good
cellular reception.
7. EITHER use the mobile DIRECTOR application on your phone to check that the
Qtanium 100 has established contact OR call DIRECTOR Support with the following
details and ask them to associate the Qtanium 100 with the asset number:

Customer Name

Qtanium 100 MSN

Asset number and asset VIN
Important Ensure that any holes drilled for the installation will not weaken the
structure of the asset or compromise the safety of the asset or its occupants. If in
doubt, consult the manufacturer.