Manual AURUS-OLED
TDS12022xx
Page | 6
↓
Cooling, now = 21°C
If your system is cooling, the LED at the down arrow will be lit, if
your system is heating, the LED at the up arrow is lit!
After 10 seconds, it shifts back to the measured temperature.
The ‘Presets’ of the Sensor Zone:
Here you can select the most
suitable preset. In case of a temperature sensor, you can choose
between: <DAY>, <NIGHT>, <ECO>
Day: This is the normal temperature setting during the day, also
called the ‘comfort’ temperature.
ECO: The ‘ECO’ value is a value which is a predefined number of
degrees different than the ‘day’ preset. In heating mode the ECO
temperature is lower then the ‘day’ preset. In cooling mode the
ECO temperature is higher then the ‘day’ preset. [ENERGY
SAVING PRESET]
Night: In case of cooling/heating this is your preferred
temperature setting during the night.
The ‘Mode’ of the Sensor Zone:
With this button you select the
mode of the sensor if applicable. Normally only available when
using cool/heat air-conditioning systems. Mode examples are
“cool/heat/auto…”.
Speed:
When your heating or cooling system is equipped with
speed control, you can manually alter the speed by pressing
LONG on the mode selection buttons.
The ‘Zone’ selection:
With this button you can scroll through
the different zones (rooms) of your house/building. Every click
jumps to a new zone and the according values for that zone are
displayed and can be changed.
Remark: each panel can be configured to show a limited number
of zones only. Please contact your system integrator for more
information.
Pressing LONG will bring up the "change presets" menu .
Zone On/Off:
will switch the displayed sensor zone ON or OFF.
In most cases this will mean your heating system will be
protected from freezing but will not heat. This feature is
particularly useful for guest- and rarely occupied rooms (energy
management feature).
