Telestream PRISM MPI2-RACK-MD, Инструкции по установке и безопасности

Страница: 25 / 29

PRISM MPI2-RACK-MD Installation and Safety Instructions 9
Figure 4: Installing the PRISM waveform monitor (not included) and extended touch display into the rack cabinet
Install instrument(s) in the rack cabinet
After you install the rack cabinet in the equipment rack, perform the following steps to install instrument(s) in the cabinet:
CAUTION. To prevent the USB and headphone cables from being damaged, make sure the cables are not in the way as
you slide the instrument into the rack cabinet.
1. Install the PRISM waveform monitor in the rack cabinet. (See Figure 4.)
a. Slide an PRISM waveform monitor into the left slot in the rack cabinet as viewed from the front.
b. Use a screwdriver with a TORX T-15 tip to secure the instrument in the rack cabinet with two 10-32 X 0.625 screws
(item 3 in Table 4). The screws attach to the top right and bottom left holes in the instrument chassis as viewed
from the rear.
c. Connect the cable from the USB port and headphone jack on the rack cabinet to the rear of the instrument. (See
Figure 5.)
d. Connect signal and Ethernet cables to the instrument as needed. See the PRISM MPI2 Installation and Safety
Instructions manual for information about making signal connections to the instrument.
e. Connect the power cable to the instrument. (See Power cord installation .)