Telestream PRISM MPI2-RACK-MD, Инструкции по установке и безопасности

Страница: 24 / 29

8 PRISM MPI2-RACK-MD Installation and Safety Instructions
Install the rack cabinet in the equipment rack
Before you install an instrument into the rack adapter, install the adapter into the rack using the following steps:
1. Position the rack cabinet so that the headphone jack(s) on the front of the cabinet is on the bottom.
2. If desired, you can adjust the position of the handle brackets to mount the adapter flush with other equipment in the rack.
To do this, loosen the nuts that attach the handle brackets to the rack adapter, adjust the position of the handle brackets
as desired, and then tighten the nuts securely. (See Figure 3.)
3. Use a screwdriver with a PosiDriv tip to attach the rack adapter assembly to the front frame of the rack with four 10-32 X
0.750 screws (item 6 in Table 4) and four shoulder washers (item 5 in Table 4).
4. Use a screwdriver with a Phillips tip to install one guide bracket (item 7 in Table 4) to one side of the rear frame of the
rack with two 10-32 X 0.625 screws (item 2 in Table 4) and one nut bar (item 1 in Table 4) as shown. (See Figure 3.)
5. Use a screwdriver with a Phillips tip to attach the guide bracket to the cabinet with two 10-32 X 0.625 screws (item 2 in
Table 4), two washers (item 4 in Table 4) and one nut bar (item 1 in Table 4). Use the holes in the bracket that will
accommodate the depth of the instrument rack frame being used. Leave the screws loose.
6. Repeat steps 5 and 6 to install the second guide bracket to the other side of the cabinet.
7. Tighten all of the attaching screws that were left loose in the previous steps.
Figure 3: Adjusting the handle brackets and installing the guide brackets