Mechanical Installation
IND1x1
is installed into a
DVX002
installation frame equipped
with a specifi ed DVX bus address (refer to the frame
installation instructions) and a
DVP412
(115 V AC) or a
DVP432
(230 V AC) power supply.
The unit can be installed into any frame position, however the
power supply is normally placed in the left-hand side of the
frame. Lock the unit into place using the locking screws on the
front panel (see picture 1).
Note! See that the “
M
” (module) -indicator lits green. If the
indicator lits red, the unit in question has a module error and is
giving an alarm. See the “
Status page
” for more information.
Mechanical Connections
1. Locking
screw.
2.
Composite video output (BNC male).
3.
S-video (Y/C) output (4 pin min-DIN female).
4.
STM-1/OC-3 interface, depending on model in
question, either RJ-45 female (when CAT5) or dual-
SC/PC (when optical).
5.
Led indicators, see section below.
6. Handle.
Front Panel Leds
When the unit is working properly, the “
M
” led on the front
panel is green. If the unit senses a module error, the “
M
” led is
red. Blinking green “
M
” led indicates that Commander software
is communicating with the unit in question.
When the ATM connection status is OK, the “
C
” led on the front
panel is green. If the ATM signal is missing or it’s level is too
low, the “
C
” led is yellow.
When the Video connection status is OK, the “
V
” led on the
front panel is green. If the video signal is missing or it’s level is
too low, the “
V
” led is yellow.
Picture 1
.
IND101 Mpeg-2 Decoder /
connections.
MPEG
DECODER
IND101
VIDEO
M
V
C
S-VIDEO
ATM
1
2
3
4
5
6
IND1x1 Series User Manual rev001 3
