5. On the bottom of the monitor plate you will
see three equidistant, recessed holes. Insert
one of the three 1/4-20 x 2 3/8 bolts through
the center bottom of the monitor plate. Slide
the frame riser over the top of the bolt.
Note: If completing these steps becomes difficult,
having a second person, or bringing the hardware to
a workbench will help make it easier.
6. Thread the bolt into the center threaded hole on
the bottom of the back bracket (which is attached to
the beamsplitter frame) and hand tighten.
7. Thread the remaining two bolts through the
bottom of the monitor plate and tighten using a
flathead screwdriver. Do not fully tighten until all
three are threaded into the bracket holes.
