18
Checking the communication with the modem
Once the modem is connected you can check RS232 or USB communication between
the RB900-Pro and the PC using any Terminal program. Configuration of the DTE (port
COM) could be as follows:
•
Bits per second:
115200 bps
,
•
Data bits:
8
,
•
Parity:
None
,
•
Stop bits:
1
,
•
Flow control:
hardware
.
Using a communication software such as Hyperterminal, enter the
AT
and
push 'enter'
button. The response of the terminal should be '
OK'
displayed in the Hyperterminal
window.
If the connection with the modem cannot be established do the following:
•
Check if modem is connected with PC via RS-232 or USB.
•
Check the configuration of the COM port.
Examples of AT commands:
•
ATE1
enables modem echo function,
•
AT+CPIN?
shows current status of SIM card
•
AT+CPIN=xxxx
to enter PIN, where 'xxxx' are digitals
•
AT+CSQ
to verify received signal strength
•
ATD<phone_number>;
to initiate a voice call
•
ATH
to hang up a voice call
For further information about AT commands and their usage, refer to [1].
Disabling and enabling echo function
If echo is not displayed when entering AT command, that means:
•
The local echo function in software (such as Hyperterminal) is disabled
•
The echo function of the modem is disabled
To enable echo function of the modem enter the
ATE1
command.
In Machine to Machine communication it is recommended to disable echo function (type
ATE0
) in order to avoid unnecessary CPU usage.
For further information about
AT
commands and their usage, refer to [1].
Содержание RB900-Pro
Страница 1: ...1 Contents...
Страница 5: ...5 References 1 Quectel_EC25 EC21_AT_Commands_Manual_V1 1 pdf...
Страница 27: ...27 RF specifications...
Страница 35: ...35...
