Telefunken TF-LED32S32T2, Инструкция по эксплуатации

Страница: 8 / 33

Operation
8
8
Operation
Changing the battery
1. Remove the battery compartment cover
on the back of the RC.
2. Insert two AAA batteries into the battery
compartment making sure that the correct
polarity is observed.
3. Put the cover back.
• The RC should be pointed at remote
sensor within 8 meters and within 30 degrees
at the left or the right side.
• Take the battery out of the RC if it is not
used for a long time.
• Do not mix new and used batteries or
different types of batteries. Weak batteries can
leak and severely damage the RC.
• Do not expose the RC to shock, liquids,
and do not place it in an area with high
humidity.
General operations
Power
• Connect the plug of the power cord to the
power supply outlet, the power indicator will
flash showing that the unit is in standby mode.
To switch on the unit press the power switch
on the back of the unit to the ON position. The
unit will be in standby mode. Press POWER/
STANDBY on the RC or unit to switch on the
unit from standby mode. Press power switch on
the back of the unit to OFF position to switch off
the power. When the unit is on, press POWER
button on the RC to switch the unit to standby.
• Do not leave your TV in standby mode for
a long period of time; if you are not going to
use the unit, disconnect it from power supply.
Basic operations
• Press VOL- button repeatedly to decrease
the volume; press VOL+ button repeatedly to
increase the volume.
• Press MUTE to mute sound, press this
button again or increase volume to resume
sound.
• Press RECALL button on the RC to select
from the present channel and the previously
displayed channel.
• Press ASPECT button repeatedly to select
a screen aspect ratio. Available aspects may
differ for different signal sources.
• Select the TV function mode. Press
CH-/CH+ buttons to select previous or next
channels; or press number buttons to enter a
channel number directly.
• Press P.MODE button repeatedly to cycle
through the available video picture modes.
• Press S.MODE button repeatedly to cycle
through the available sound modes.
• Press DISPLAY button to display the
preset TV channel play information.
• Press FREEZE button to freeze the picture
on or off.
• Press AUDIO button in ATV mode
repeatedly to switch between various Nicam
sound modes (can be unavailable for some
channels). This function is optional.
Signal sources
Press INPUT button, then press DOWN/UP
cursor buttons on the RC or CH+/CH- buttons
on the panel to select a source from available
source list: DTV => ATV => AV => => YPbPr
=> HDMI 1 => HDMI 2 => HDMI 3 => PC
=> USB. Press ENTER button on the RC to
confirm.
Teletext operations (option)
Select a TV channel in order to pick up
the picture signal of Teletext. Teletext button
functions are as follows:
TTX: Press this button to enter into TEXT
mode. Press the button again to return to the
channel you are watching.
HOLD: Press this button to stop the move
to the next page. Press this button again to
cancel operation.
INDEX: Press this button to go to the index
page.
REVEAL: Press this button to reveal the
concealed information. Press this button again
to conceal the information.
Red/Green/Yellow/Blue buttons: Press
these 4 color buttons to access directly to
corresponding color page displayed at the
lower parts of teletext screen.