English
- 8 -
Power Connection
IMPORTANT:
This set top box is designed to operate on 12V DC. For this, an adaptor is used
which gives 12 V voltage. Connect this adaptor to a system that supplies 220-240 V AC, 50/60Hz.
After unpacking, allow the set-top box to reach the ambient room temperature before you connect
the set to the mains.
Note:
If a car cigarette lighter socket power plug adaptor is going to be used, it should be noted that if the
output voltage reduces to lower than 12V, a smartcard error can be caused.
to POWER INPUT
DC 12V Terminal
AC Adaptor
Power On-Off
Be sure that you put through all the cable connections. After plugging in the power adaptor cord
of the set-top-box to the mains supply, a LED will be seen on the front panel (Standby mode).
When the set-top-box is first powered up please wait for a while before activating the receiver
since booting of software will take some time. Then, you can turn on your digital set-top box by
pressing the standby button on the remote control. You will see that the LED on the front panel
will change (Power on mode).
Auto Power Down:
This box will automatically be switched from active mode into standby mode, after less than four
hours in active mode, following the last user interaction and/or a channel change with an alert
message two minutes before going to standby mode. The Automatic power-down will be set as
default and the user will be able to change Automatic power down to on or off in the menu
Antenna Connection
Back side
of the set top box
This illustration shows how to connect an antenna. Use
ANTENNA IN
to connect to an antenna
system.
