Telefunken TB 251, Быстрый старт

Страница: 16 / 47

Important information
This document is only a quick-start
guide. Full operating instructions are
available on the website
www.telefunken-digital.com .
The default language of your phone is
English, if you want to change it, please
follow these instructions:
1. Press , scroll
▼ to “Handset” and
press .
2. Scroll
▼ to « Language » and press
.
3. Scroll
▲ or ▼ to select your preferred
language and press to confirm.
Siting the base
A site should be chosen with the
following characteristics:

A flat and stable surface

At most 2 meters from a power outlet
and a telephone jack

At least 1 meter from any other
electronic appliance to avoid
interference

Out of direct sunlight and a sufficient
distance from any heat source

Away from any wet or damp area,
such as a bathroom
Note: since the base and the portable
handset communicate via radio waves,
it is important that the base is located in
an open area to ensure the best
possible signal. The normal range is
approximately 300 meters when there is
a direct line of sight to the base, and
approximately 50 meters when the base
is indoors and the phone is outdoors.
Thick concrete walls significantly reduce
this range. The symbol on the
portable handset indicates when you are
in range of the base. Whenever you are
outside range of the base, the
symbol blinks, and a warning tone is
emitted.
Connecting the base
1. Under the base, plug the power cord
holding a clear connector in the plug
labelled .
2. Connect the other end of the power
cord into the power wall outlet. The
device switches on, as indicated by
the red light from the base.
3. Under the base, connect the
telephone jack to the plug labelled
and the other end into the
telephone connector plug. Then plug
the connector to the telephone wall
jack.
4. Verify that the red light of the base is
lit.
Recharging the handset
1. On the handset, slide the cover and
insert the 2 NiMH batteries supplied.
Always observe the direction of
insertion. Close the lid.
2. Place the handset on the base and
allow charging for at least 24 hours
before its first use, until the handset
icon indicates .
3. If necessary, do the same for other
handsets.