- 8 -
Hot-pluggable SFP modules as follows:
Hot-plug procedure:
Observe the end with PCB gold finger during SFP
Insert the golden finger end into the metal shielding cage of the SFP, and
hear a clicking sound to indicate that the device has been inserted in place,
and then put the SFP plug-in handle on the normal position parallel to the
interface.Then it means we can use it.
Hot pull steps:
First pull the SFP's plug handle perpendicular to the interface,the optical
device should be disconnected from the hook of the SPF shielding cage at this
time.
Pull out the SFP module in parallel
Notice
This switch uses lasers to transmit signals on fiber optic cables. The
laser meets the requirements of Class 1 laser products and normal operation
is harmless to eyes. However, when the equipment is powered on, do not
look directly at the optical transmission port and the end face of the optical
fiber terminator.
The steps to connect the pluggable fiber optic module are as follows:
Remove and keep the rubber cover of the ST/SC/FC. When not use, put
on a rubber sleeve to protect the optical fiber terminator .
Check the optical fiber terminator if it is clean. Slightly moisten a clean
paper towel or cotton ball, and gently wipe the cable plug. Dirty optical fiber
terminator will reduce the quality of optical transmission and affect port
TELE2210G-2GF-8GT Full Gigabit Din-rail mount Industrial Ethernet Switch
www.telefly.cn
