Teleflex Marine MV3-E Series, Инструкция по установке и эксплуатации

Страница: 8 / 16

Page 8 User Manual: MV3-E Hybrid Controls
Shift Cable Connection - Engine End
See engine or stern drive instructions for shift cable connection.
Installation
Shift Cable Connection - Control End
Connect Shift Cable To Control
1. Insert shift cable through opening in hanger assembly in line with shift arm pivot attachment hole and lock
cable in hanger slot.
. Screw pivot onto cable rod, allowing threads to protrude through pivot 1/8” for standard travel or 1/4” for
long travel.
3. Lubricate pivot with grease, then insert into required hole in shift arm. fasten with cotter pin. Tighten cable
nut against pivot.
CAUTION:
The pivot must be in the hole nearest to the cable entry end of the control. Using the hole in the shift
arm (furthermost away from the cable mounting) support will produce unequal shift travel between the
“neutral to forward’ and the “neutral to reverse” positions; resulting in improper shift action.
To obtain standard ( 3/4 inch) cable shift travel at the engine use the shift arm on the control at the short pivot
hole location.
for Mercury, long (3 inch) cable shift travel at the engine is necessary. Assemble the shift arm to the control
using longest pivot hole location.
NOTE: The Control Shift Lever and the Transmission Shift Lever must coincide at the "Forward," "Neutral,"
and "Reverse" positions. Different makes of transmissions my require different amounts of shift travel. For
this reason, the Control Shift Lever is provided with two positions for attaching the shift cable: one for the
standard travel and one for the longest travel.