Teledyne UA-6, Инструкция по установке и эксплуатации

Страница: 26 / 122

UA-6 Detector
Section 2 Preparation for Use
2-2
Note
If the recorder has been sitting overnight, tear off about three
inches of chart paper to preclude the possibility of the paper
rolling around the drum.
To install the pen (refer to Figure 2-1):
1. Slide the pen cartridge into its holder. A dimpled clasp
holds it in place.
2. Remove the pen cap (a press fit) and lower the pen with the
pen lift arm (left of the roller) to ready the pen for use.
Replace the pen cap on the pen when the recorder is not in
use to prevent the tip from drying out.
3. To remove the pen, pull the cartridge straight out of the
holder.
Figure 2-1 Recorder Chart Paper and Pen Installation