Teledyne UA-6, Инструкция по установке и эксплуатации

Страница: 21 / 122

UA-6 Detector
Section 1 Introduction
1-5
Figure 1-2 UA-6 Front Panel
Table 1-2 Front Panel Controls and Indicators
Item in
Fig. 1-2
Control or Indicator Description Function
1 STANDBY-OPERATE
Switch 2 position selector switch In OPERATE, applies secondary power to the unit.
In STANDBY, applies secondary power to heaters.
When unit is connected to the main power source,
primary power (100, 117, or 234 VAC) is present at
all times.
2 RECORDER Strip chart recorder Traces on graduated chart paper to indicate and
record the light absorbency of a medium in the
optical unit light path.
3 PEAK SEPARATOR
off, 0.3, 1, 3, 10, 30+ Rotary selector switch Turns peak separator on, optimizes the peak sepa-
rator for various peak widths in minutes.
4 CHART SPEED-CM/HR
0.3, 0.6, 1.5, 3, 6, 15, 30,
60,150, 300 Rotary selector switch Stops and starts recorder chart drive and selects
speed ranges from 0.3 to 300 cm/hr.
5 PEAK SLOPE LED Indicator lamp Lights green to indicate positive slope detected.
Lights red to indicate negative slope detected.
6 AUTO BASELINE Momentary push button Used to activate baseline circuitry. Provide
rapid coarse baseline adjustment.