Teledyne T3CP100-2, Руководство пользователя

Страница: 4 / 20

Page 1
Safety Instructions
Follow these instructions to keep the probe operating in a correct and safe condition. Observe generally
accepted safety procedures in addition to the precautions specified here. The overall safety of any
system incorporating this product is the responsibility of the assembler of the system.
Symbols
These symbols appear on the probe body or in documentation to alert you to important safety
considerations.
Precautions
Comply with the following safety precautions to avoid personal injury or damage to your
equipment:
Use only as specified . Using the probe and/or the equipment it is connected to in a manner other than
specified may impair the protection mechanisms.
Do not use the probe for measurements on Mains circuits. The probe should only be applied
around or removed from insulated, limited-energy circuit conductors that are not directly connected to
the mains.
Do not overload; observe all ratings. To avoid electric shock or fire, do not connect the current probe
to any wire that carries voltages or currents that exceed the ratings of the probe.
Connect and disconnect properly . Connect the probe to the test instrument before connecting to
the circuit/conductor being measured.
Avoid damaging the cable through excessive bending.
CAUTION , possibility of electric shock.
CAUTION of damage to probe or instrument, or WARNING of hazard to health. Attend
to the accompanying information to protect against personal injury or damage. Do not
proceed until conditions are fully understood and met.
Do not apply around or remove from UNINSULATED HAZARDOUS LIVE conductors
which may render electric shock, electric burn, or arc flash.
Equipment protected by double insulation or reinforced insulation.
CAUTION , hot surface.
!
!
sss