Teledyne Princeton Instruments FER785-MM, Руководство пользователя, Страница: 12 / 28

12 FER785-MM Diode Laser Source User Manual Issue 2
4. Insert the Safety Key Card into the slot labeled KEY on the rear of the laser housing.
See Figure 3-2 .
Figure 3-2: FER785-MM Diode Laser Source: Rear of Housing
5. Insert a 3.5 mm mono plug that is wired in series with room or safety enclosure
remote interlock circuitry into the Remote Safety Interlock Connector (ILOC) on the
rear of the housing. See
Figure 3-2 .
NOTE:
If remote safety interlocks are not being used, an interlock
defeating pin is provided to allow the laser source to
operate. Insert the interlock defeating pin now or proceed
to
Chapter 4, Remote Safety Interlock Connections , on
page 15 for information about properly setting up interlock
connections.
6. If using USB control, connect the host end of the cable to an available USB port on
the host computer and the peripheral end to the port labeled USB on the rear of the
housing. See
Figure 3-2 .
7. Connect the power supply to the laser by plugging the DC jack into the PWR socket
on the rear of the housing. See Figure 3-2 .
4
4
11
-0
15
7_
00
05
DC P
OWER
I
NPUT
USB 2.0 P
ORT
R
EMOTE
S
AFETY
C
OAXIAL
I
NPUT FOR
S
AFETY
K
EY
C
ARD
I
NTERLOCK
C
ONNECTOR
PULSE M
ODE