Teledyne PIXIS-XF, Системное руководство, Страница: 80 / 116

80 PIXIS-XF System Manual Issue 5
5. The next time you start the WinX/32 application, the new name will be displayed on
the Hardware Setup dialog. See Figure 7-4 .
Figure 7-4: Camera Name on Hardware Setup Dialog
6. If you later re-run the Camera Detection Wizard, the name will be changed back to
the default name (i.e., Camera1).
7.5 Controller Is Not Responding
If this message pops up when you click on OK after selecting the Interface Type during
Hardware Setup on the WinX/32 Setup menu, the system has not been able to
communicate with the camera. Check to see if camera has been turned ON (i.e., is
connected to the switched on power supply) and if the USB 2.0 interface card, its driver,
and the USB cable have been installed.
• If the camera is ON, the problem may be with the USB 2 card, its driver, or the
cable connections.
• If a USB 2 interface card is not installed, close the WinX application program
and turn the camera OFF. Follow the installation instructions in provided with
your interface card, and cable the card to the USB 2 port on the rear of the
camera. Then do a Custom installation of WinX/32 with the appropriate
interface component selected. Be sure to deselect the interface component
that does not apply to your system.
• If a USB 2 interface card is installed in the computer and is cabled to the USB 2
port on the rear of the camera, close the application program and turn the
camera OFF. Check the cable connections.
• If the USB 2 interface card was installed after the application program was
installed, close the application program and do a Custom installation of
WinX/32 with the appropriate interface component selected. Be sure to
deselect the interface component that does not apply to your system.
4
4
11-
01
12_00
5
0