Teledyne PIXIS-XF, Системное руководство

Страница: 42 / 116

42 PIXIS-XF System Manual Issue 5
5.3 LightField First Light
This section provides step-by-step information about acquiring an image in LightField
for the first time. The intent of this procedure is to help you gain basic familiarity with
the operation of your system and to show that it is functioning properly. Once basic
familiarity has been established, then operation with other operating configurations,
ones with more complex timing modes, can be performed.
The following procedure assumes:
• You have already set up your system in accordance with the instructions in
Chapter 4, System Setup , on page 27 and are verifying the camera system
operation.
• You have read the previous sections of this chapter.
• You are familiar with the application software.
• The system is being operated in imaging mode.
Perform the following procedure to verify initial system operation:
NOTE:
This procedure is based on LightField. Basic familiarity with
the LightField software is assumed. If this is not the case,
you may want to review the software manual or have it
available while performing this procedure.
1. Power on the camera (i.e., switch the power supply on.)
2. Turn on the host computer power.
3. Launch LightField.
Once LightField is running, you should see an icon representing your camera in the
Available Devices area.
Figure 5-3 illustrates a PIXIS-XF:1024F.
Figure 5-3: Typical LightField Available Devices Area
4
4
11
-0
112_0
018