Teledyne PIXIS-XF, Системное руководство, Страница: 32 / 116

32 PIXIS-XF System Manual Issue 5
3. After the installation finishes, reboot the computer.
4. Connect the PIXIS-XF system components to your computer and power them on.
5. Start LightField, activate it, and begin setting up your experiment.
4.5 Make Camera-Circulator Connections for a CoolCUBE
II
For liquid-cooled cameras, the CoolCUBE
II
circulator provides a vibration-free method
of heat removal. Figure 4-3 illustrates a typical CoolCUBE
II
circulator.
Figure 4-3: Typical CoolCUBE
II
1. Make sure the camera and the circulator power switches are turned off.
2. Make sure the circulator is 6 inches (150 mm) or more below the camera. The
vertical distance should not exceed 10 feet (3 m). Typically, the camera is at table
height and the circulator is on the floor.
3. Make the coolant connections between the circulator and the camera. It does not
matter which hose from the circulator is plugged into a coolant port on the camera.
4. It is recommended that hoses be secured to the camera hose barbs with the clamp
supplied.
NOTES:
1. Make sure that there are no kinks in the hoses that
impede the coolant flow. Lack of sufficient flow can
seriously harm the detector and any resulting damage is
not covered under warranty.
2. Damage caused by water leaking into the PIXIS-XF voids
the warranty.
5. Unscrew the reservoir cap located on top of the CoolCUBE
II
and make sure that the
coolant reservoir contains coolant. If additional coolant is required, fill with a 50:50
mixture of water and ethylene glycol.
6. Screw the reservoir cap back in.
7. Plug the circulator into a 100-240 V
AC
, 47-63 Hz power source.
4
4
11
-0
112
_0013
R
ESERVOIR
C
AP
C
OOLANT
P
ORTS