M41d HBR3 Video Analyzer/Generator - Quick Start Guide
Rev. A1
Page 8
Rev A6 - May 29, 2020
Note:
The eDP header block is used for controlling the backlight of an
eDP display. The pinout and functions are shown below.
eDP Pin Configurations:
1. BL_Enable (Possible Future Rx input)
2. BL_Enable (Tx Output)
3. BL_PWM_DIM (Possible Future RX input)
4. BL_PWM_DIM (TX Output)
5. Ground
6. Ground
4.4
Gettting the M41d Up and Running
Use the following procedures to get your M41d up and running.
1. Remove the M41d from the shipping box and lay it flat or upright on
your desktop or benchtop.
2. Connect the M41d power cable (provided) to a suitable outlet
(110-240V 50/60Hz). The power socket is on the back of the M41d
as shown below.
3. Connect an external HDMI or DisplayPort monitor to the HDMI or
DisplayPort connectors on the back of the M41d
; labeled “External
Monitor
” at the location indicated below.
