Teledyne 965 Five-Station, Инструкция по установке и эксплуатации

Страница: 13 / 22

965 Five-Station Battery Charger
1-5
1.4 Grounding and AC
Power Connections
The Model 965 Five-Station Battery Charger should always be
grounded to reduce the risk of electrical shock. The charger has a
power cord with an equipment grounding conductor and a
three-pronged grounding plug. Attach this plug only to a
three-pronged outlet that is properly installed and grounded in
accordance with the National Electrical Code and all local codes
and ordinances.
WARNING
Before using the grounding adapter shown in Figure 1-3,
make sure the center screw of the outlet plate is grounded.
The green-colored rigid ear or lug extending from the
adapter must be connected to a properly grounded outlet.
Make certain it is grounded. If necessary, replace the
original outlet cover plate screw with a longer screw that
will secure the adapter ear or lug to the outlet cover plate
and make the ground connection to the grounded outlet.
The Model 965 Battery Charger is made for use on a nominal 120
or 240 volt 50-60 Hz AC circuit. The model supplied for use in
the U.S.A. and Canada has a 120-volt three-prong grounding
plug that looks like the plug shown to the left in Figure 1-3. A
temporary adapter can be used to connect this plug to a 2-pole
receptacle (as shown to the right in Figure 1-3) if a properly
grounded outlet is not available. The temporary adapter should
be used only until a properly grounded outlet can be installed by
a qualified electrician.
4
Connector for Charging Batteries
This connects to both Isco-made nickel-cadmium and lead-acid batteries.
5
Battery Selector Switch
This switch must be in the proper position for the type of battery (nickel-cadmium or lead-acid).
NOTE: You cannot charge both battery types at once!
Table 1-1 Front and Rear Panel Controls/Connections (Continued)
Item Function