Teledyne 340CF ELSD, Инструкция по установке и эксплуатации, Страница: 12 / 46

340CF ELSD
Section 1 Quick Start Guide
1-4
1.2 Connecting to the
Combi Flash ® Torrent
The Combi Flash Torrent system is designed to handle a variety
of large-scale purification needs, with various methods of sample
introduction and collection.
Connection of the Torrent to the ELSD requires the connection
package, part #60-5247-021. The package contains the following:
1. Tee fitting with reducer
2. Two 0.25" mounting spacers for tee
3. Two #6x1" pan head screws/flat washers/lock washers
4. 1 pc
1
/
16
OD x 0.02" ID x 6" long tubing
5. 1 pc 0.25 OD x 0.188" ID x 100cm long black PTFE tubing
w/ metal nut and ferrule swaged on each end
6. 1 pc 0.25 OD x 0.188" ID x 100cm long black PTFE tubing
w/ nut and ferrule swaged one end and a union on the
other end
To connect the ELSD to the Torrent:
1. With a
3
/
32
" Allen wrench, remove the PEEK tee fitting and
metal tubing from the rear panel of the ELSD unit (refer to
Figure 1-5).
2. Using the two long screws with lock and flat washers,
mount the metal tee fitting on the rear panel, aligning the
two standoffs over the ELSD’s threaded mounting holes,
and the mounting holes in the tee over the two standoffs.
Figure 1-5 Replace the PEEK tee with the metal tee fitting
3. Locate the 6" piece of tubing. Attach one end to the bottom
of the metal tee fitting and the other end to the ELSD liq-
uid inlet (refer to Figure 1-7). Tighten fittings to finger,
tight.
4. On the Torrent, disconnect the black PTFE tubing end
from the bottom column connection (Figure 1-6).
Standoffs (place over
threaded holes)
Threaded
mounting holes