Teledyne 2103, Инструкция по установке и эксплуатации

Страница: 20 / 94

2103 Modem Module
Section 2 Preparation and Installation
2-6
2.5 Connecting to
Flowlink
After the 2103 is installed and the modem cable connected, you
need to establish that there is a modem at the site, by config-
uring the module in Isco’s Flowlink software.
Note
The 2103 Modem requires Flowlink 4.13 or later. Earlier ver-
sions do not support the modem.
The first time you connect to the site, you must connect your
computer directly to the stack using Isco’s RS232 connect cable
( p a r t # 6 0 - 2 0 0 4 - 0 4 6 ) o r U S B p o r t c o n n e c t c a b l e
(part #60-2004-507). Open Flowlink and go to the Connect screen
(Figure 2-3) by either selecting it from the pull down menu or
clicking on the Quick Connect icon.
Make sure the connection Type is Direct, and click on the 2100
Instrument icon to connect. Upon initial connection, Flowlink
creates a site file and adds it to the database. If the system
detects the addition of a new module to an existing site, it will
display the Network Resolution screen (Figure 2-4).
Figure 2-3 Flowlink connect screen