TELEDYNE OLDHAM SIMTRONICS OLCT 80 d, Руководство пользователя

Страница: 68 / 116

OLCT 80
GAS TRANSMITTER
USER MANUAL
62 NPO80GB
Revision F.1
Figure 48: micro switch configuration on the
OLCT 80
.
•
Position the microswitches as shown below (Figure 49, A) after opening the cover of the
master receiver:
Switch No. 1 2 3 4 5 6 7 8
Position ON ON
OFF OFF OFF OFF OFF OFF
Figure 49: micro switch configuration on the
master
receiver.
5.6 Configuring the addresses
5.6.1 Configuring addresses on
OLCT 80s
Each sensor (main sensor,
ANA1, ANA2) will have its own address for communication with the
MX43 central controller according to the configuration of the controller (refer to the document
entitled
MX43 Central Digital and Analog Measurement Unit - User Manual).
Follow the steps below:
•
Configure the addresses of the
OLCT 80 as indicated under Serial connection
configuration on page 38.
•
Calculate the address of the OLCT 80's internal wireless care by adding 50 to the slave
number of the main sensor.
Example: one OLCT 80 transmitter with one ANA1 input used:
Address of the main sensor: 1.
Address of the ANA1 sensor: 2.
Address of the OLCT 80's internal wireless card: 51 (i.e., 50 + 1).