TELEDYNE OLDHAM SIMTRONICS Everywhereyoulook MultiFlame DF-TV7, Руководство по эксплуатации

Страница: 7 / 64

MULTIFLAME DF-TV7
OPTICAL FLAME DETECTOR
OPERATING MANUAL
NOSP17662
Revision 03
1
1 Product Description
MultiFlame DF-TV7-T was designed to detect hydrocarbon fires, while minimizing false alarms.
This detector is equipped with an intelligent optical self-test. It is certified and may be installed in
SIL2 level system. It can be directly connected to a wide range of traditional or fire controllers
and on Programmable Logic Controllers (PLC).
DF-TV7-T can be fully configured using the portable communication terminal (TLU600), providing
flexibility to the user. Time delay, sensitivity and outputs configuration can be full set up via the
TLU600, a hazardous area approved remote control. Optical and electronic parts, and outputs
(current, relay…) of the detector can be controlled by the TLU. The DF-TV7-T can be configured
too by the HART communication terminal, TLH700 (in option).
Concerning to the Type-D detector, some operations can be done with the magnetic wand
(CEDPC led, flame simulation, LT15 test)
The MultiFlame product family consists of two detector versions:
•
DF-TV7-T multi-spectrum IR Flame detector
•
DF-TV7-V combined UV and IR
The MultiFlame models are also available for use in an addressable network system with
distributed intelligence SYNTEL. This version is named DF-RV7-*. For more information, please
refer to the Syntel module interface operating manual.
1.1 Applications
•
Refineries
•
Drilling and Production Platforms
•
FPSO
•
Fuel Loading Facilities
•
Compressor Stations
•
LNG/LPG Processing and Storage
•
Gas Turbines
•
Chemical Plants
•
Aircraft Hangars
•
Sports (Stadia / Gymnasia)
The sensitivity of flame detector depends on many factors including, fuel type, fire size,
atmospheric conditions (wind, rain, fog, etc...), the angle between the fire and detector as well
as line of sight obstructions.