Teledyne Lecroy USB2-GPIB, Руководство пользователя

Страница: 4 / 12

USB2-GPIB Adapter
2
USB2-GPIB Overview
The USB2-GPIB Converter enables you to remotely control an oscilloscope
from a PC using standard GPIB commands.
The GPIB connector conforms to IEEE488.2 standard. Its delimiter setting is
LF+EOI. Note that the USB2-GPIB does not function as a GPIB controller.
The USB connector conforms to USB 2.0. The source voltage is supplied from
the USB port.
GPIB driver needs to be properly configured to allow HS488 high speed mode,
including proper definition of the cable length.
For details of the supported GPIB commands, see the
MAUI Oscilloscopes
Remote Control Manual and Automation manual on the Teledyne LeCroy website.
The minimum MAUI firmware version required for this device is 7.3.0.x.
Specifications
Power Feed Bus-powered
USB Standard USB Specification Revision 2.0
USB Connector Type A
GPIB Connector Amphenol 24-pin (male)
Power consumption 350 mA maximum (during operation)
Temperature, operating +5 °C to +40 °C
Temperature, storage -40 °C to +71°C
Humidity, operating ≤ 80% RH (non-condensing)
Altitude, operating 3048 m (10,000 ft) max at ≤ 25 °C
External Dimensions (mm) 61 (W) × 22 (H) × 113 (L) (mm)
Cable Length (mm) 750
Mass Approx. 140 g
Specifications subject to change without notice.