Distributor of Teledyne LeCroy: Excellent Integrated System Limited
Datasheet of PP016 - PASS PROBE 10:1 300MHZ-WAVEACE
Contact us: [email protected] Website: www.integrated-circuit.com
Operator’s Manual
922209-00 Rev A
7
Certifications
This section certifies the probe’ Safety and Environmental compliance.
EC Declaration of Conformity - Safety
The probe meets intent of EC Directive 2006/95/EC for Product Safety. Compliance
was demonstrated to the following specifications as listed in the Official Journal of
the European Communities:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
Measurement Category II (CAT II), measurements performed on circuits
directly connected to the low-voltage installation.
Pollution Degree 2, operating environment where normally only dry non-
conductive pollution occurs. Conductivity caused by temporary
condensation should be expected.
Environmental Compliance
E
ND
-O
F
-L
IFE
H
ANDLING
The instrument is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The instrument is subject to disposal and recycling regulations that
vary by country and region. Many countries prohibit the disposal of
waste electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne LeCroy product,
please visit teledynelecroy.com/recycle.
R
ESTRICTION OF
H
AZARDOUS
S
UBSTANCES
(R
O
HS)
This instrument has been classified as Industrial Monitoring and Control Equipment
and is outside the scope of the 2011/65/EU RoHS Directive until 22 July 2017 (per
Article 4, Paragraph 3).
10 / 13
10 / 13