This procedure describes the assembly process for the Type 2260 bracket (to install the other types follow the
same procedure):
1. Place the Extension bracket aligned with the counter sink screw holes.
2. Make sure the text "Type 2260" on the bracket is facing the top of the PCB where the cables are attached.
3. Insert the screws and tighten them using a 1.4mm Phillips or flat blade screw driver.
4. The view from the top side of the PCB is shown below. The text "Type 2260" is clearly visible.
Interposer DUT Standoff Installation
A flexible attachment M.2 standoff assembly is provided for the different types of DUTs supported which are
2240, 2260, 2280, and 22110. Move the M.2 standoff based on the DUT Type. The standoff will be attached to
2280 location by default. The standoff has a nut on the bottom side which can be removed by hand or with a nut
driver (see drawings on next page).
4
Warning
!
Attempting to use the board without the extension bracket and properly secured to the host will cause
damage to the plug-in card of the interposer cable and warranty will be voided.
