Power On/Off Button
: Press and release the button to power on or power off the system.
Status Indicators
: Colored LEDs show the status of power and capture.
Table 1: X240 Front Panel Status Indicators
Antenna SMA Connectors:
Antenna attaching points.
Excursion Mode
: When configured Excursion mode, pressing this button will begin data
capture - the same as the Record/Recording button on the X240 Window Datasource
toolbar. The
Excursion Mode
button is inactive when X240 is connected to a computer. To
operate in the Excursion mode, the X240 hardware must have been previously configured
from the
Wireless Protocol Suite
prior to disconnecting from the computer. The X240
hardware will retain those configuration settings when disconnected from the computer.
Refer to the Wireless Protocol Suite Hardware and Software User Manual for Excursion
mode operating details.
Oculink Connectors:
For connection to Frontline 8 channel PODs used for hardwired
connection to user’s equipment under test.
Note:
At this time the Oculink connectors are inactive.
Indicator
Color
State
Status Indicated
Power
None
Off
Unit is powered off
Purple
Constant
Insufficient Power
Green
Constant
Unit is switched on
Red
Fast Flash
Unit is approaching its maximum
thermal load and should be shut down.
Constant
Unit has reached thermal overload or
Unit has started a
controlled/sequenced shutdown.
Status
None
Off
Unit is powered off
Yellow
Slow Flash
Initializing (may not be seen if
initialization is quick)
Fast Flash
Unit is shutting down.
Constant
Unit is in Recovery Mode.
Green
Constant
Unit is initialized and ready to capture.
Blue
Slow Flash
Unit is waiting for a Trigger (future).
Fast Flash
Unit is capturing in Excursion mode or
capture is not "OK" (future)
Constant
Unit is capturing data
Red
Constant
The unit failed to initialize or has a
System Error.
RF
None
Off
Unit is powered off or Unit is not
actively capturing data.
Green
Constant
Unit is capturing Bluetooth data.
Red
Fast Flash
The RF signal is too strong.