12
www.teledex.com
I SERIES ANALOG USER GUIDE
If you are talking on the speakerphone and wish
to transfer to the handset, pick up the handset
from the cradle. The speakerphone LED will go
out and the call can be continued on the handset.
MUTE (SPEAKERPHONE-EQUIPPED
MODELS ONLY)
1. To mute a call, press the MUTE key. The
red MUTE LED will light. You will continue
to be able to hear the other party, but they
will not be able to hear you.
2. Press the MUTE key again to turn off the
mute feature. The MUTE LED will go out.
CONFERENCE (TWO-LINE MODELS
ONLY)
On two-line telephones, the CONFERENCE key
allows the user to include two other parties in a
three-way conversation. After placing or receiving
a call to/from the first party, place that party on
hold by pressing the HOLD key. Using the second
line, place or receive the second call. Press the
CONF key to join all three callers.
USING THE HOLD KEY (TWO-LINE
MODELS ONLY)
TO PLACE A CALL ON HOLD
1. With a call active, press the HOLD key.
2. The red line LED will change to a slow
blink indicating the call is on hold.
TO REMOVE A CALL FROM HOLD
1. Press the line key of the call on hold. This
removes the call from hold.
2. The red line LED will remain illuminated
for the duration of the active call.
CHANGING PHONES AFTER PLACING A CALL
ON HOLD
1. Place the call on hold, as above.
2. Pick up the call at another telephone that
is on the same line.
REDIAL
To redial the last telephone number dialed:
1. Lift the handset from the cradle, or press
the SPEAKERPHONE key.
2. Press the REDIAL key. The last number
dialed will be redialed.
Programming
GUEST SERVICE KEYS
Depending on your I Series model, there may
be programmable guest service keys located
above the dialpad. These keys can be used for
one-touch access to commonly dialed numbers
or services. To program these auto-dial keys,
the telephone must be connected to an active
telephone line.
Programming of these keys is protected from
unauthorized tampering, and employs the use
of hidden programming keys located underneath
the faceplate. With the clear plastic overlay and
faceplate removed from the phone, locate the
STORE key as noted in the phone diagram. This
recessed key is located above number 3 in the
dialpad.
To program an auto-dial, or guest service, key:
1. Lift the handset from the cradle, or press
the SPEAKERPHONE key.
2. Press the recessed STORE key and release
it.
3. Enter the number or extension to be
programmed.
4. Press the auto-dial key where the number
is to be stored.
5. Repeat steps 3–4 as necessary for
additional auto dial keys.
6. Place the handset back in the cradle,
or press the SPEAKERPHONE key to
disconnect.
I SERIES A SERIES PHONES (ANALOG CORDED)
