www.teledelta.com
Page 3
Dropbox\TeleDelta\HD Products\HD100 Network Encoder\HD100 Quick Start Guide rev2.1
Installation
1.
Connect your peripheral cables (HDMI/SDI and MIC) to the correct ports on the back of the
unit. Insert the SD card or USB disk if you are going to be using either of these media for
recording or playback.
2.
Connect an Ethernet cable from a management network to the unit RJ45 port. During the
initial set up of your device it is advised you do this to a local terminal before introducing it to
your network.
3.
Connect the power adapter, the unit will automatically boot itself once power is applied.
Note: It is important to maintain appropriate ventilation when installing. When installing the
HD100 into a rack environment please allow 1/3 RU above and below your installation for
appropriate ventilation. Inappropriate ventilation may cause heat dissipation issues which in
turn can damage your unit.
Logging In
The HD100 can be managed through its web-based GUI.
1.
Open a web browser (Internet Explorer, Firefox or Chrome; Edge is not recommended) and
navigate to the HD100 IP address:
IP Address of HD100 is 192.168.1.100
Login parameters are:
Username:
admin
Password:
admin
Status Page:
Once logged in
–
you
’
ll be presented with the below landing page which has key monitoring and
system information on the HD100s status, this is the status page
