Telecor VS-600, Руководство пользователя

Страница: 31 / 32

VS-600 Resident Unit Manual C-9
C.8 Wiring and Mounting Resident Unit
Before wiring and mounting a Resident Unit ensure its diagnostic procedure has been performed
(section B.1) and that it has been properly programmed (section B.2) .
The VS-600 Resident Units are installed onto standard 3-gang backboxes, with a minimum depth
of 2.5”. The rear of the unit has two standard RJ-11 jacks. Holding the unit right side up, the
upper jack terminates to a PEU station port and the lower jack terminates onto the Tip and Ring
terminals on the back of a phone wall plate. The resident telephone then connects to this wall
plate.
See diagram on next page for overall view of configuration described above.
USOC (Universal Service Ordering Code) is the wiring standard that should be followed for
installing the Resident Unit. Wiring should adhere to the color code for USOC 2-conductor
(analog/voice) telecommunication lines as shown below.
USOC Wiring
Cable Wall Plate Jack
White w/ blue stripe Green
Blue w/ white stripe Red