Teleco Flat Sat Classic Smart 65, Инструкция по установке и эксплуатации

Страница: 5 / 32

Warning:
NEVER loosen the two dish arm lock
screws (A) to attach the dish as this
will result in loss of alignment with
the antenna.
YES NO
Important notice
Flat Sat Elegance Smart is packaged in two separate cartons for transport reasons:
a) the first package contains the driving unit with all the cables, and the control box.
b) the second package only contains the dish.
• It is important to check that the dish has not been damaged during transport when the
package is opened. In particular, check the following well:
• By resting the dish edge against a flat surface (e.g. the floor or a wall) check that it makes
contact to the surface all around. If it is not so, try and make the edge level, without denting
the dish, or call our After-Sales Service.
• After checking that everything is in order, install the dish on the driving unit as follows:
1) Connect the Control Unit and the TV as described on page 11 "Connections"
2) Press the AUTO key of the TV remote control and wait (about 30 seconds) for the
dish support arm to lift up.
3) Once you have reached the desired position, disconnect the power supply cable to
switch off the Flat Sat Elegance Smart.
4) Secure the dish to the mast and screw down the four supplied screws.
5) Turn the unit on again and wait for the antenna to close.
6) Disconnect the Control Unit,
the battery and install the driving
unit on the vehicle.
4