Telecast Adder TD161, Инструкция по эксплуатации

Страница: 6 / 16

Adder™ TD161
Installation
Unpacking
The Adder TD161 consists of:
• One Adder TD161 tap and drop unit
• One external power supply (AC/DC adapter)
• Plastic covers for optical connectors
• Pre-installed rack mount adapters
After unpacking, inspect the unit for mechanical damage and inspect all electrical
connectors for bent or damaged pins. Report any damage to the carrier and to
Telecast Fiber Systems, Inc.
Leave the protective plastic caps on the optical connectors until you are ready to
attach the fiber to the modules. Replace the caps on the connectors whenever the fiber
is disconnected.
Removal of Rack Mount Adapters
Modules are shipped ready for rack mount use. On the TD161, all connections are
made to the rear panel; place each module in its intended location before attaching any
cables or wires. This will prevent accidental damage to the cables or their connectors.
The rack mount adapters on either side of the front of the module may be removed for
bench use of the system and to minimize unit width.
Each adapter is held in place by two #10 Phillips head screws (see Figure 2). Remove
these two screws and store the adapters and screws for future use.
Figure 2: Removing the Rack Mount Adapters
2