TeleAlarm 970-170g, Руководство по установке

Страница: 43 / 100

GSM Module Programming and testing | en 43
TeleAlarm Installer Manual 970-170g | V1.7 | 2015.09
If the GSM Module is activated and a GSM media is entered, the
firmware version of the GSM Module is announced by the
Carephone when you enter the programming mode:
– The Carephone’s version and build are announced.
– The Carephone beeps.
– The GSM Module firmware version is announced.
3.3 Test the GSM Module signal strength
– Enter test mode: press P and A together for at least 1 sec.
– The Carephone announces "test" .
– Press 9, 2 and C .
The red lamp flashes for 3 minutes, the Carephone indicates
the signal strength by announcing a digit between 0 and 5 :
– 0 means the signal is weak, 5 means the signal is strong.
If an error is coming back or if the GSM Module doesn't
answer, the message is simply replaced by a "beep".
– Exit the test mode by pressing any button on the
Carephone. After 3 minutes, it automatically exits.
3.4
GSM connectivity indication on a Carephone
The blue lamp on a Carephone equipped with a GSM Module
indicates the connectivity status in the following cases:
– When programming a Carephone remotely or via keyboard
– When the Carephone experiences a reset, initialization or
power supply interruption.
– When updating rhe the GSM Module firmware

If there is no connectivity, the blue lamp flashes.
After a maximum supervision time of 60 seconds, if the
connectivitiy is not established, a "line failure" technical
message is generated by the Carephone.
NOTICE!
The signal strength test mode is available only if the GSM
Module is correctly inserted in the Carephone and initialized,
and that a destination number with GSM media is entered. Do
not move the Carephone afer the signal strength test.