English
TS6213
5
3 First time installation
When all the connections on the receiver are ready (section 2.2) and the power lead is plugged in, the
receiver will start up automatically. If this does not happen, press the button on the front panel of the
receiver or on the remote control.
An easy installation menu will be displayed where you can set different parameters and then run the channel
scan:
Step 1 – OSD Language
Use the arrow
◄
/
►
button to select a language for the On Screen Display menu (OSD). Press
▼
to go to
the next parameter.
Step 2 – Region
Use the arrow
◄
/
►
buttons to select your Country. Press
▼
to proceed.
CAUTION
If a wrong Region is selected the channel scan may not detect all the channels available.
Step 3 – LCN Mode
When the Logical Channel Numbering option is active, after the scanning, the TV/Radio services will be
automatically stored in the list following the order requested by the broadcasters. Press
▼
to go forward.
NOTE
When
LCN
mode is turned on, we suggest to not change the channel positions in the
TV/Radio Channel List
menu.
Step 4 – Tuner Power
If you are using an active antenna press
◄
/
►
to power the antenna; this is necessary when, for instance, an
indoor amplified antenna has to be powered by the receiver.
CAUTION
With a traditional antenna, like typical rooftop models, or an independently powered antenna, the antenna power option
must be set to off: risk of overload!
Step 5 – Password Definition
Press OK on
New Password
field and input a 4-digit numeric password (PIN), then reinsert the same
password on
Confirm Password
and push OK again. Press
▼
to proceed.
CAUTION
Password definition for Parental Control (par. 4.2) is mandatory for completing the installation.
Step 6 – Channel Scan
Press OK item to start the automatic channel scan. When the scan is completed, if there are no LCN conflict
the receiver will enter the viewing mode, otherwise see below step.
Step 7 – LCN Conflict Resolution
When the LCN function is active and more than a service asks for the same channel list position, the system
will recognize that conflict and display on screen a list of the involved services. Choose the preferred channel
by using
▼
/
▲
arrow buttons e confirm with OK. As an alternative, go to the automatic solution. Also, if the
user doesn’t make a choice, after a few time the appliance will carry out a solution by itself. After these
actions, the receiver will enter the viewing mode.
Step 8 – Time Setting
We suggested to check the time setting. Press MENU and go to
Setup
-
Region and Time
menu, choose
the proper
Summer Time
option (
Off
/
On
) or change another type of time regulation (par. 4.5).
Step 9 – Video Configuration
For TV SCART output settings, go to
Setup
-
TV System
menu and regulate
Aspect Ratio
(
16:9 Full
Screen
/
Pillar Box
or
4:3 Letter Box
/
Pan Scan
) and
Video Output
(
RGB
or
CVBS
) respecting the technical
characteristics of the connected screen.
