TELE System Hybrid BLOBbox
8
6 Safety regulation
We advise you to read the following advice concerning the safety regulations carefully in order to ensure
ELECTRICAL SUPPLY
•
The appliance should only be supplied by a current of 230 Volt AC, 50Hz.
•
Do not remove the cover. The inside of the appliance could contain higher voltages than that of the supply
voltage which could endanger the user. High voltage is also present when the appliance is on standby. The
receiver should be disconnected from the electrical supply before performing any intervention. Non-authorized
removal will mean that the warranty is no longer valid!
POWER CABLE
•
Before installing the appliance make sure that the cable is intact, paying particular attention to its connection
to the power supply and to the receiver. If the cable is damaged do not attempt to connect the appliance and
refer the problem to an authorized center for assistance.
•
When installing the cable make sure that it can not be flattened in any way by items placed above or next to
the appliance. Avoid placing the cable in an area where it could accidentally be stepped on, removed from the
wall or damaged in any way.
•
If the cable is damaged in any way carefully disconnect from the appliance and refer to specialized
technicians.
LIQUIDS
•
Keep the appliance far from any liquids. Do not place any objects containing liquids on the appliance, such as
vases, humidifiers etc. The appliance must not be installed in areas where it could come into contact with
sprays or drops of water or in an environment with a high level of humidity where condensation could occur.
•
If the receiver should accidentally come into contact with liquids, disconnect immediately from the wall.
SMALL OBJECTS
•
Keep the receiver away from coins or other small objects. Objects which fall into the appliance via the
ventilation gaps could cause serious damage.
CLEANING
•
Before cleaning, disconnect the device from the power supply.
•
To clean the outside of the receiver use a soft and dry or slightly damp cloth. Avoid using products which
contain chemicals or solvents.
VENTILATION
•
Make sure that the area where the appliance is to be installed has good air circulation so that the heat can be
dissipate well in order to avoid overheating.
•
In order to allow enough ventilation it is necessary to have a distance of at least 10 cm on either side of the
appliance and 15cm above the appliance.
•
The vents must be kept clear from any obstructions such as newspapers, table cloths, furnature material,
curtains, carpets etc.
•
Avoid installing the receiver close to any heat sources (i.e. radiators, stoves etc) or on top of any other
appliances which omit heat (Video players, DVD, etc)
WARNING!!!
•
Keep the appliance out of reach of children.
•
The plastic bags used for packaging can be dangerous. To avoid suffocating keep the bags out of reach of
children.
•
Do not expose the receiver or remote control to direct sunlight.
•
The appliance must be placed on a solid and stable base.
•
Connect the device to the power supply only after installation is complete.
•
Dispose of the product correctly so as to avoid damage to the environment and human health as well as to
facilitate recycling of the components/materials used in the appliance. If the product is not disposed of properly
this could be punishable according to the involved law.
•
The manufacturers recommend that the parts are recycled separately and are taken to sites which conform to
current regulations.
•
Take the product when no longer usable to a collection point which is authorised to handle waste
from electrical or electronic appliances that should be kept separate from regular household waste.
•
In case of fire or blaze danger, the main plug/switch and other devices must be completely
disconnected from the receiver
•
