9.2 Register the transmitter in the receiver
Registering means establishing communication between the transmitter and the
receiver.
RISK OF UNINTENDED EQUIPMENT OPERATION
Only transmitters that are intended for use should be registered in the
receiver.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
NOTE: To establish a radio link between the transmitter and the receiver, both
units must be set to the same radio mode.
NOTE: The registration instructions require access to the receiver housing. For the
registration procedure to be successful, the receiver must be powered up.
RISK OF UNINTENDED EQUIPMENT OPERATION
Do not perform this action when the receiver is in a session with another
transmitter. The radio communication may be interrupted or broken.
Failure to follow these instructions could result in death, serious injury,
or equipment damage.
1. Set the transmitter in registration mode (see relevant Tele Radio AB
transmitter installation instructions).
2. Press the receiver
Function
button.
The function LED1 lights (red).
3. Press the receiver
Select
button.
All relay LEDs light (red).
4. Press buttons 1 and 2 on the transmitter to be registered in the receiver (see
relevant Tele Radio AB transmitter installation instructions).
All function LEDs light.
5. Release the transmitter buttons.
If the transmitter is registered, all relay LEDs flash 3 times.
If no transmitter is found within approximately 10 seconds, the receiver exits to
normal operation.
42
IM-PN-RX107-CERT-01pre4
PRELIMINARY
