Chapter 2: SAFETY
2.1 Safety
To ensure safe operations this manual must be carefully read and understood before installing and
operating the product. Installation must be made by authorized and educated personnel and
according to the local laws and regulations. Failure to follow these instructions may cause death,
serious injuries and material damages.
User
The following details must be considered for all handling of the system.
l
Hydra products must not be operated without access to the manual, the technical doc-
umentation and needed safety training. The purchaser of this Hydra has been instructed how
to handle the system safely.
l
Allow only licensed or qualified personnel to install the product.
l
Allow only qualified personnel to have access to the transmitter and operate the equipment.
l
Make sure that the user follows the instructions.
l
Make sure that the user satisfies the age requirements in your country for operating the equip-
ment.
l
Make sure that the user is not under the influence of drugs, alcohol or medications.
l
Make sure that the user does not leave the transmitter unsupervised.
l
Make sure that the user always switches the transmitter off when it is not in use.
l
Make sure that the user has a clear view of the work area at all times. The work area must be
free from obstacles and the user must be sure of his/her footing.
l
The user may not use broken products.
l
The user may not change any configurations without proper training.
l
The user may not remove any labels from the product.
l
The user may not use the product when the battery is low.
Installing, connecting and mounting
When installing, connecting and mounting the following must be considered at all times.
l
Write down the serial numbers/ID codes of the receivers and transmitters used.
l
Allow only licensed or qualified personnel to install the product.
l
Always switch off the power supply to the receiver before connecting the equipment.
l
Check that the power supply is connected to the correct connection terminal.
l
To utilize the safety of the system, use the stop relays in the safety circuitry of the object
that you want to control
5
