Fig. 9:
Installing the transparent protector
3.3 Power Source
The Regesta Lite AU router must be powered in DC voltage. The nominal power voltages are 24V DC.
Note
Before connecting the router, please read the following instructions carefully!
3.3.1 Power Buffer
The Regesta Lite AU has a special feature: the Power Buffer. This feature allows the device to keep working for a
few seconds after the power goes off.
3.3.2 Workplace Conditions. Main Characteristics
• The device should not be placed amongst papers, magazines or other elements that could hinder natural air circu-
lation.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in
Connecting
on page 11 and
Disconnecting
on page 11.
3.3.3 Connecting the Power Supply
To connect the power supply to the device, please follow the steps set forth in section
Connecting
on page 11.
Warning
To avoid electric shocks, residual current circulation and other unwanted effects, also affecting commu-
nications, the following is recommended:
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply
or it is independent from the rest (such as lighting, etc.); it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
lems of drivers and other components.
3 Components and Power Supply
Teldat S.A.
10
Regesta Lite AU
